SATO iGT400 Series, Instruction Manual

Page: 55 / 102

The print density (darkness) can be set in five levels.
Check if the “Print density setting” screen is shown as the following
on the display.
3
Print density setting
PRINT DARKNESS
1 2 3 4 5
[8 dots/mm] default: 06 IPS
[12 dots/mm] default: 06 IPS
[24 dots/mm] default: 03 IPS
02, 03, 04, 05, 06, 07, 08, 09, 10, 11, 12 IPS (inch/sec)
02, 03, 04, 05, 06, 07, 08, 09, 10, 11, 12 IPS (inch/sec)
02, 03, 04, 05, 06 IPS (inch/sec)
● The numbers 1 to 5 show the print density (darkness).
1 is the lightest, and 5 is the darkest.
● Press the / buttons, and the cursor moves to the left or
right.
● Press the button, and the setting is registered, and the
next setting screen will appear.
● The initial value is 3.
ENTER
2
Print speed setting
The print speed can be set in 11 steps in GT408 and GT412,
and five steps in GT424.
If quality printing cannot be obtained due to the paper or the
printing contents, lower the speed.
Check if the “Print speed setting” screen is displayed as the
following on the display.
PRINT SPEED
06 IPS
● The numbers 02 to 12 show the print speed.
● 02 inches/sec is the lowest speed, and 12 inches/sec is the
highest speed.
●
Change the set value with the / buttons, select a
number, and set the print speed.
● Press the button, and the setting is saved, and the
next setting screen will appear.
●
The initial value is 6 inch/sec. for GT408, 6 inch/sec. for
GT412, and 3 inch/sec. for GT424.
ENTER
50
サトー取説_E 04.8.17 6:22 PM ページ 50