Satel AMD-100, Manual

Page: 11 / 12

SATEL AXD-200 9
14. Depending on the detector type and configuration, make sure that the LED comes on:

AMD-200
:
– after moving the magnet away (opening the window or door),
– after violating the detector connected to the additional input M1.

AMD-201
:
– after moving the magnet away (opening the window or door),
– after violating the detector connected to the additional input M1.

AMD-202
:
– after moving the magnet away (opening the window or door),
– after violating the detector connected to the additional input M1,
– after raising / lowering the roller shutters supervised by the roller shutter detector.

AVD-200
:
– after moving the magnet away (opening the window or door),
– after impact against the surface protected by the detector.
The shock detector range depends on the type of surface on which the detector is
installed. The specified detection range (up to 3 m) should be considered an
approximate value. The actual range should be determined experimentally after
securing the detector to the surface.

ARD-200
– after changing the detector position.

AFD-200
– after submerging the flood probe in water.
15. For the water flood detector, when the test is done, secure the FPX-1 probe as shown in
Fig. 8.
3.1 Selecting detector type
1. Install the battery in the detector. The detector LED will start flashing rapidly.
2. Within 10 seconds of inserting the battery, knock 3 times on the detector enclosure. The
LED will flash to indicate the selected detector type – see Table 2.
Number of LED flashes Detector type
1 Magnetic contact (AMD-200)
2 Dual channel magnetic contact (AMD-201)
3
Magnetic contact with input for roller shutter detector
(AMD-202)
4 Shock detector and magnetic contact (AVD-200)
5 Reorientation detector (ARD-200)
6 Temperature detector (ATD-200)
7 Water flood detector (AFD-200)
Table 2.
If you do not want to change the detector type, wait for about 10 seconds. If there are
no impacts within 10 seconds, the detector type selecting procedure will be
terminated. The LED will indicate once more what type is saved in the detector
memory.