Satel AMD-100, Manual

Page: 6 / 12

4 AXD-200 SATEL
ARD-200
The detector reports alarm when it senses a change in its position. The detector remembers
position at the moment of being switched into active mode or starting the test mode. Fig. 1
shows the changes in orientation that can be sensed by the detector.
ATD-200
The detector reports alarm when it registers a temperature higher / lower than the predefined
threshold. The detector allows you to program two critical temperature thresholds: low (L)
and high (H). The detector will alert of the threshold being exceeded if the temperature:

drops below the value preprogrammed for the
low (L)
threshold,

rises above the value preprogrammed for the
high (H)
threshold.
Information about the current temperature is sent when the detector connects to the
controller / control panel.
AFD-200
The detector reports alarm approximately 5 seconds after the water level reaches the height
at which the probe is installed. The detector reports end of flooding a few seconds after the
water level drops below the height at which the probe is installed.
Operating modes
Active
– information about each alarm is sent immediately.
Passive
– only information about tamper alarm is sent immediately. This operating mode
prolongs the battery life.
The detector operating mode is turned on remotely. If the detector is used in the INTEGRA /
VERSA alarm system, the operating mode may depend on the partition state (partition
disarmed – passive mode; partition armed – active mode). For more information, refer to the
ABAX 2 / ABAX controller manual / the INTEGRA 128-WRL control panel manual.
Energy saving mode (ECO)
If you want to prolong the battery life, you can enable in the detector the “ECO” option. When
the “ECO” option is enabled, the periodical communication takes place every 3 minutes. Thus
the battery life can be increased as much as fourfold. The option is only available in the
ABAX 2 system. The detector with “ECO” option enabled meets requirements of the
EN50131-2-6 standard for Grade 2.