Satel AMD-100, Manual

Page: 9 / 12

SATEL AXD-200 7
Simultaneous operation of the detector by the ABAX 2 and ABAX controller /
INTEGRA 128-WRL alarm control panel is not possible.
4. Close the detector enclosure.
5. Put the detector at the place of its future installation.
6. Check the level of signal received from the detector by the ABAX 2 / ABAX controller or
the INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select another
place for installation. Sometimes, it is sufficient to shift the device ten or twenty
centimeters to obtain a considerable improvement in the signal quality. You can also try to
turn the enclosure to check what effect the change of antenna position will have on the
signal strength.
The ARF-200 tester makes it possible to check the radio signal strength at the place of
future installation without having to put the detector there.
For the shock detector (AVD-200), check also the detector range in the selected
location of installation.
7. Open the detector enclosure (Fig. 3).
8. If detectors or flood probe are to be connected to the additional input terminals, make
a hole in the enclosure base, run wires through the hole and secure them to the terminals.
9. Use wall plugs (anchors) and screws to secure the enclosure base to the mounting
surface (Fig. 4). The wall plugs delivered with the device are intended for concrete, brick,
etc. For other types of surface (drywall, styrofoam), use the appropriately selected wall
plugs.
10. Close the detector enclosure.
11. In the case of the magnetic contact (AMD-200 / AMD-201 / AMD-202 / AVD-200), secure
the magnet (Fig. 5). taking into account the maximum permissible distance from the
magnetic sensor (Fig. 6). The distance shown applies to the magnet located at the sensor
height. Location of the sensor in the enclosure is shown in Fig. 7.
To make the hole for flush magnet, use the ø9 mm drill bit.
12. Configure the detector settings (see the ABAX 2 / ABAX controller manual / the
INTEGRA 128-WRL control panel manual).
13. Start the test mode (see the ABAX 2 / ABAX controller manual / the INTEGRA 128-WRL
control panel manual).