SAS/op/proc/forks/op manuals/Ex/EXTREME MANUAL
v13
.pub 2/24/2019
Page 9
© 2014-2019 S.A.S. of Luxemburg, LLC.
INSTALLATION: PREPARATION (PAGE 9)
SAS™ EXTREME™ AUTO PROCESSOR
COMPONENT IDENTIFICATION
ADVANCE PREPARATION BEFORE ARRIVAL & INSTALLATION OF EXTREME AUTO PROCESSOR
Review this operator manual. Review operator, safety & service manuals of excavator manufacturer.
Items you need to obtain before arrival of Extreme™ Auto Processor:
Excavator must have two bi-directional auxiliary hydraulics at the end of the stick with cab controls.
Excavator must have one filtered free flow drain line back to tank
Hydraulic fluid (specific for your machine). Identify fluid check and fill points.
Identify and obtain needed hydraulic hose quick connections on your machine and fitting required.
Locate supplier to make hydraulic hoses (Minimum recommend 19 mm (3/4”) diameter, 34 Mpa
(5,000 PSI) hoses and fittings once proper length is determined during installation.
Tools your mechanic may need for installation:
Sockets, wrenches, large adjustable wrench, large rubber hammer, hydraulic bottle jack, grease gun
Service to do on your excavator in advance:
Have maintenance personnel replace hydraulic system filters & fluids (as needed)
Pressure and flow test. Have pressure results available. Set pressures between
24-31 Mpa, 240-310 Bar (3,500-4,500 PSI). Not to exceed 31 Mpa, 310 Bar (4,500 PSI)
Inspect pins & bushings in arm and dozer blade for wear (replace as needed)
SAS has no responsibility as to performance of excavator’s hydraulic system with this attachment.
Available for training:
Designate an area (i.e. where it is safe to run equipment) and an employee to operate unit
Designate operator who can read and speak English, if SAS staff onsite to assist your mechanic.
Installation Hazards (Additional details covered elsewhere in this manual):
Pinch & crush points, High pressure hydraulics, Stored pressure, Skin injection risk
Installing this Extreme Head & Hold Down Assembly will change lifting dy-
namics & likely reduce lift capacity and reduce stability of the excavator
.
Installer and operator must use caution in establishing reasonable lift capacities. Consider Head &
HDA attachment weights and excavator manufacturer’s manual guidance. These hazards may cause
equipment damage, injury or death. Only qualified persons should complete installation.
HYDRAULIC
ROTATOR
ASSEMBLY
CLAWS
HOLD DOWN
ASSEMBLY
“
HDA
”
WIRE
STRIPPER
INSTALLATION
LIFT EYELETS
HEAD
ASSEMBLY
“
HEAD
”
S.A.S. of Luxemburg, LLC. 133 Center Drive Hwy 54, PO Box 260, Luxemburg, WI 54217 USA
Phone: 920-845-2307
1-877-SAS-FORK
Fax: 920-845-2309
Web: www.sasforks.com
PATENTED JAWS & tips
