SAS/op/proc/forks/op manuals/Ex/EXTREME MANUAL
v13
.pub 2/24/2019
Page 14
© 2014-2019 S.A.S. of Luxemburg, LLC.
S.A.S. of Luxemburg, LLC. 133 Center Drive Hwy 54, PO Box 260, Luxemburg, WI 54217 USA
Phone: 920-845-2307
1-877-SAS-FORK
Fax: 920-845-2309
Web: www.sasforks.com
INSTALLATION OF SAS™ EXTREME™ AUTO PROCESSOR HEAD ASSEMBLY:
INSTALLATION SHOULD BE COMPLETED BY AN EXPERIENCED HEAVY EQUIPMENT MECHANIC
1. Remove existing bucket and inspect pins and bushings.
Replace as needed.
2. Line up palletized head assembly with machine as
shown in image (i).
Note: Head weight approximately:
Model EX-25, standard: 1,400 kg ( 3,000 lb )
Model EX-35, large: 2,064 kg ( 4,550 lb )
3. Lower stick of excavator down to line up with hole at top of
assembly and insert and secure pin “A” into head assembly.
4. With pin “A” secure in head assembly, lift assembly so that
only the tips of the head assembly are resting on pallet as
shown in image (ii). Align curl linkage to other hole in head
Assembly mount. Insert and secure pin “B” into head assembly.
5. Connect hydraulic hoses 34 Mpa, 344 Bar (5,000 psi)
Jaw (Grapple) & Rotator minimum hose dia. 19 mm (3/4”).
Motor drain (case drain) free flow hydraulic return 12.5mm (1/2”)
SAS has no responsibility as to performance of
excavator’s hydraulic system with this attachment.
Connection jaws ( Fittings: 12 ORFS )
Maximum Pressure
31 MPa, 310 Bar (4,500 psi)
Maximum Flow
130 L/min (35 gpm)
Connection rotator ( Fittings: 12 ORFS )
Maximum Pressure
31 MPa, 310 Bar (4,500 psi)
Model EX-25 (Rotator RLP-902)
Maximum Flow 45 L/min (12 gpm)
Model EX-35 (Rotator RGP-1302)
Maximum Flow 125 L/min (33 gpm)
Connection drain ( Fittings: 10 ORFS )
“D” Drain line must be connected to
the drain line filter on the carrier.
INSTALLATION: HEAD (PAGE 14)
SAS™ EXTREME™ AUTO PROCESSOR
A
B
AFTER INSTALLATION PRIOR TO OPERATION
1. Grease all pivot points with Head and Hold Down resting on ground and machine engine off.
2. Read excavator manufacturer’s manual to identify control levers operation, method to stop mo-
tions, safety parameters related to operation of the excavator with any specialized attachment.
3. Stay clear of pinch points. Slowly engaging controls, test all motions of Head Assembly.
Watch for interference points and stop further motion if interference occurs.
(i)
(ii)
