Sanyo SPW-C256VH, Technical Data & Service Manual

Page: 514 / 517

8
3. Pass the wire from the wireless receiver through the grille. (Fig. 8-34)
4. Fit the panel to the indoor unit and connect the wire from the receiver to the connector (CN130/WL/WHT/10P)
on the indoor control board. (Fig. 8-35)
5. After fi xing the panel in place, fi t the receiver to the panel taking care not to trap the wire from the receiver.
6. Clamp the receiver wire and panel wire together with the supplied clamper. (Fig. 8-35)
7. Insert the receiver wire and panel wire into the wire saddles. (Fig. 8-35)
*Refer to the Users Manual supplied with the panel.
NOTE
1. Do not twist the receiver wire and the power lead-in wire together as this could lead to malfunction.
2. If the unit power source is affected by noise, install a noise fi lter or take similar measures.
Fig. 8-34
Fig. 8-35
Receiver
Panel wire
Pass wire through panel
Receiver wire
Clamper
CN130 [WL]
(WHT 10P)
Panel wire
Wire saddle
8-24
SM830160-03̲Classic̲PAC-i̲A4.ind24 24 SM830160-03̲Classic̲PAC-i̲A4.ind24 24 2010/02/16 10:31:23 2010/02/16 10:31:23