Sanyo 1 852 351 85, Technical & Service Manual

Page: 75 / 164

Operation with the
Remote Control Unit
1. Automatic Operation
STEP 2
STEP 1
This unit automatically switches between cooling opera-
tion and heating operation according to the difference
between the room temperature and the temperature
setting.
panel is turned on.
Check that the circuit breaker on the power
Once mode is selected and the unit is preset by
following the steps below, you can have the air condi-
STEP 1 Press the MODE selector button to .
STEP 2 Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF operation
To change the temperature setting; press
the temperature setting buttons and change
the setting to the desired temperature.
NOTE
NOTE
2. Manual Operation
STEP 1 Press the MODE selector button and
select the desired mode.
For heating operation
For dehumidifying operation
For cooling operation
For fan only operation
STEP 2 To start the air conditioner, press the
ON/OFF operation button.
STEP 3 Press the TEMP. setting buttons to
change the temperature setting to the
desired temperature.
Adjustable temperature range:
the setting you want.
STEP 4 Set the FAN SPEED selector button to
STEP 5 Press the FLAP button and set the airflow
direction as desired.
(Refer to “Adjusting the Airflow Direction”
on page 13.)
To stop the air conditioner, press the ON/OFF operation
button again.
30 °C max.
16 °C min.
STEP 2
STEP 5
STEP 3
STEP 1
STEP 4
• Choose the best position in the room for the
remote control unit, which transmits the
operating instructions. Once you’ve found
this best position, always keep the remote
control unit there.
• This appliance has a built-in 5-minute time delay
circuit to ensure reliable operation. When the
operation button is pressed, the compressor will
start running within three minutes. In the event of
power failure, the unit will stop. NOTE
tioner automatically bring the room to the desired
temperature simply by pressing the ON/OFF operation
button.
button again.
Check that the circuit breaker on the power
panel is turned on and that the operation
selector of the indoor unit is in the ON position.
If the automatic operation settings of the unit
do not meet your needs, press the setting
buttons as described below and change
the settings as desired.
NOTE
9