27
Instruction Manual for ASEPT.1X Max
1-888-726-8869
www.sanuvox.com
ELECTRICAL RATINGS, POWER CONSUMPTION & AVAILABLE VOLTAGE
The product is rated at 120V or 240V, and 50 Hz or 60 Hz, 193W.
See product label to confirm power consumption of your specific unit or system.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CUSTOMER SERVICE FIRST OR SEE YOUR WARRANTY.
DO NOT RETURN THE PRODUCT TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE
PRODUCT OR TAMPER WITH ITS COMPONENTS WITHOUT CONTACTING CUSTOMER SERVICE FIRST. DOING SO
MAY VOID YOUR WARRANTY AND CAUSE PERSONAL INJURY OR DAMAGE TO THE PRODUCT.
TROUBLESHOOTING
If your product is not working properly, refer to the following.
Problem
Possible Cause
Solution
The unit LED indicator is OFF
The power switch is OFF.
Power ON the unit using the toggle
switch.
The power outlet provides no current.
Check with a qualified electrician that the
current provided is consistent with the
rate for your unit.
The switch connections are not secure.
Firmly secure each wire.
On the electronic board, the # 1 fuse is
burnt.
Replace fuse with appropriate part
number.
On the electronic board, the test point
output does not provide 3.3V.
Change power supply: Contact Sanuvox
to get one.
On the electronic board, the # 2 fuse is
burnt.
Replace fuse with appropriate part
number.
The door is not properly closed.
Make sure that the door is properly
closed (contact closed).
On the electronic board, the motion
sensors (PIR) LED (D4) is RED
PIR 1 and PIR 2 are damaged.
Change PIR 1 and 2.
NOTE: If both motion sensors (PIR) are functioning,
the PIR LED on the electronic board will flash when
the PIR detect a presence.
Contact your contractor for all your needs in terms of replacement parts:
power cord, magnetic contact, detectors, ballast, UV lamp, etc.
