11
§
3
3
.
.
4
4
S
S
e
e
t
t
t
t
i
i
n
n
g
g
V
V
o
o
l
l
t
t
a
a
g
g
e
e
f
f
o
o
r
r
M
M
e
e
a
a
s
s
u
u
r
r
e
e
m
m
e
e
n
n
t
t
D
D
i
i
s
s
p
p
l
l
a
a
y
y
This section describes how to specify an input/output voltage for measurement display.
If you have connected the UPS to a collector unit, change this setting according to the specifications of the
collector unit.
①
Press
to display the LCD screen.
②
Press
to change the home menu to the one shown below.
③
Press
to accept it.
④
In the same way, follow the figure below to make selection at each level, as follows:
“Home menu”
→
“Settings group”
→
“Settings”
→
“Values”
⑤
Use
to switch values, and then press
to select a desired value. When the confirmation screen appears, press
again to accept the value.
⑥
Press
to return to the home menu.
*1. Pressing
repeatedly cycles through the
displayed items. If you miss a desired item,
just keep on pressing until you see it again.
*2. To return to the previous level, press
.
*3. When you switch to the values screen, the
value shown is the current value, which is
indicated by “
> >
” .
*4. When a value has been changed and accepted,
it is indicated by “
>>
” (current value).
Settings group
Settings
Home menu
STATUS
MEASUREMENT
SETTING
MAINTENANCE
CONTROL
SETTING
SET IN/OUT
SET IN/OUT
Voltage
SET I/F
SET OPERATION
SET BATTERY
SET FUNCTION
SET SYSTEM
FREQ Range
D i s p l a y
>> 200V/200V(S)
Values
100V/100V
D ispl ay
200V/100V
1
2
3
Details on settings and values
Value
Description
200V/200V(S)
If rated input voltage and output
voltage are both 200V type
This is the default setting for S2 type or single-type.
If the voltage is set to 200V, 220V, 230V, 240V, or 208V, this is
the value used. If S2 type or single-operation type is used,
do not change this setting.
200V/100V
If rated input voltage is 200V and
output voltage is 100V
For W1 or W2 type, the default is different depending on the
UPS model.
If the PDU unit's terminal block is modified, change the value
according to the specification.
For details on terminal block settings and values, refer to the
A11J Instruction Manual.
100V/200V
If rated input voltage is 100V and
output voltage is 200V
100V/100V
If rated input voltage and output
voltage are both 100V
200V/200V
If rated input voltage and output
voltage are both 200V
These are the values of voltage and current that appear on the LCD screen when UPS measurements are displayed.
If you change the voltage, the current is also changed.
If the value is different from the UPS rated voltage, the measurements will not be displayed correctly.
If you have performed the operation described in §3.22 “Resetting Values of Settings”, the value becomes “
200V/200V(S
)”.
[SELECT] = OK
[
BACK] = Cancel
STATUS
S ET I N/OU T
D ispl ay
D ispl ay
> > 20 0V/1 00V
Confirm
Accept
Example: Set display voltage to “
200V/100V
”
Frequency
100V/200V
SET DEFAULT
200V/200V
Tip
*1
*2
*3
*4