SANDVIK CH420:01, Installation Manual

Page: 6 / 110

Table of contents
4 © Sandvik SRP AB – Doc. no. S 223.510 en Ver. 1 CH420:01
6. Mechanical installation and connections
6.1 General requirements ......................................................... 74
6.2 Foundation .......................................................................... 75
6.2.1 Rubber dampers .................................................... 76
6.2.2 Crusher with rubber dampers on a new concrete
foundation .............................................................. 77
6.2.3 Crusher with rubber dampers on a steel supporting
structure ................................................................. 79
6.3 Crusher assembly ............................................................... 80
6.3.1 Install feed hopper.................................................. 80
6.4 Hoses and pipes – General ................................................ 81
6.5 Hydroset and lubrication systems ....................................... 82
6.5.1 Oil tank unit ............................................................ 82
6.5.2 Water/oil heat exchanger ....................................... 83
6.5.3 Air/oil heat exchanger ............................................ 84
6.6 Over-pressure system......................................................... 85
6.7 Guards, platforms and covers ............................................. 87
6.7.1 Guards and covers ................................................. 87
6.7.2 Platforms ................................................................ 87
6.8 Lubricants ........................................................................... 87
7. Electrical installation
7.1 General requirements ......................................................... 90
7.2 Overview ............................................................................. 90
7.3 Motors and heating elements.............................................. 91
7.3.1 M1 – Crusher motor ............................................... 91
7.3.2 M2 – Lubrication pump........................................... 91
7.3.3 M3 – Heat exchangers ........................................... 92
7.3.4 M6 – Hydroset pump .............................................. 92
7.3.5 E7 – Oil heaters ..................................................... 92
7.3.6 M8 – Over-pressure blower.................................... 92
8. Final installation checks
8.1 Installation and connection checks ..................................... 94
8.1.1 Lubrication system and Hydroset checks............... 94
8.2 Electrical checks ................................................................. 95
8.3 Safety checks...................................................................... 96
8.4 Start-up ............................................................................... 96