SANDVIK CH420:01, Installation Manual

Page: 79 / 110

6. Mechanical installation and connections
77 CH420:01 © Sandvik SRP AB – Doc. no. S 223.510 en Ver. 1
6.2.2 Crusher with rubber dampers on a new concrete
foundation
See appendix A: Installation drawings .
Design the concrete foundation and its reinforcement to match the load
information in the installation drawings. Consider also the bearing strength
and nature of the ground under the foundation.
The concreting work must be carried out by experienced personnel.
Installation
a) Cast in anchor plates for the four rubber compression mountings.
Use anchor plates which are at least 25 mm (1") thick.
b) Make sure that the mounting points are level and properly grouted. Use
shims to level. Max deviation at load application point: ±1 mm.
c) Carefully clean any dust and oil from the area beneath the crusher.
d) Install the rubber dampers on the crusher’s feet. Make sure that the lower
fixing plates (7) are attached to the dampers.
(Continued)
WARNING!
Hanging load
Keep clear of hanging loads. See
section 2. Safety precautions
.
The cone crusher weighs approximately 5600 kg (12300 lb). Make sure
that the SWL (Safe Work Load) of the lifting equipment is sufficient for
the load.
NOTE! Anchor plates are not supplied by Sandvik.
1
2
3
6
5
4
7
5
6
1 Locking nut
2 Washer
3 Upper fixing plate
4 Rubber compression
mounting
5 Screw
6 Washer
7 Lower fixing plate
Rubber dampers on
anchor plates