S&P SLIM Series, Manual

Page: 5 / 72

5
1. INTRODUCTION
Thank you for purchasing a SLIM heat recovery unit. This product has been manufactured according to rigorous techni-
cal safety rules in full compliance with applicable EU standards.
Please read this instruction book carefully, as it contains important information for your safety during the installation,
use and maintenance of this product.
Keep it at hand for future reference. Please check that the appliance is in perfect condition when you unpack it, as all
factory defects are covered by the S&P guarantee.
The installation of this product (implementation, connections, commissioning, maintenance) and all other interventions must
be performed by a professional applying the recognized rules of good practice, standards and safety regulations in force. It
must conform to the prescriptions related to Electromagnetic Compatibility (EMC) and the Low Voltage Directive (LVD).
S&P shall not be held responsible for possible injuries and/or damages caused by the non-compliance with safety ins-
tructions or following a modification of the product.
2. SAFETY INSTRUCTIONS AND “CE” MARKING
S&P technicians are firmly committed to research and development of ever more effi cient products and in compliance
with current safety regulations.
The instructions and recommendations given below reflect current regulations, principally regarding safety, and there-
fore are based on compliance with general regulations. Therefore, we recommend to strictly follow the safety regula-
tions in force in your country. S&P will not be held liable for any possible harm or damage caused by non-compliance
with the safety regulations, as well as caused by modifying the product.
• Wear appropriate IPE (Individual Protection Equipment) before any intervention.
• Before installing the air treatment unit, make sure that the support and placement are suffi ciently resistant to withs-
tand the unit’s weight and that of the accessories.
• Do not open the access doors without first switching off the electrical power supply with the main power switch pre-
sent on the unit.
• If the work is to be performed inside the device, switch off the electrical power supply on the main circuit breaker and
make sure that no one can accidentally switch it on.Make sure that the moving parts are stopped.
• Make sure that the motor driven fans are not accessible from the connection taps (connection duct or screened pro-
tection).
Before starting, check the following points:
• Make sure that the device does not contain any foreign body.
• Make sure that all the components are attached in their original placements.
• Check manually that the fans do not rub or are not blocked.
• Check the earthing connection.
• Make sure that the access doors are properly closed.
• Make sure the mains voltage corresponds to the voltage indicated on the specifications plate of the unit.
The CE mark and the corresponding declaration of conformity are proof of the product’s conformity with current EU
regulations.
3. GENERAL INSTRUCTIONS
3.1. ACCEPTANCE-STORAGE
In case of missing, non-conforming, or totally or partially damaged delivered products, the Purchaser must make writ-
ten reservation on the transporter’s receipt and confirm them within seventy-two (72) hours by sending a recommended
letter to the transporter, as well as a copy to S&P. Acceptance of the equipment without any reservation will deprive the
Purchaser of any subsequent recourse against us. The product must be stored in an area protected from bad weather,
shocks and stains due to splashings or splatterings of any kind during its transport from the supplier to the end custo-
mer and onto the worksite before installation.
3.2. APPLICATION
The SLIM heat recovery units are designed for double flow air ventilation and air treatment applications in public and
private buildings:
• Indoor installation.
• Outdoor air operating temperature limits (with preheater): -20ºC / +40ºC.