- 24 -
FP120D,FP145D
(5) Insert the die with the retaining pin into the master die, die number always towards you.
(6) Release the pull pin.
(7) After installing all dies, make sure they are straight and properly seated in the master dies.
Manual mode in used during die set change, set-up and test run and when swaging special fittings.
(1) Select MANUAL MODE.
(2) Press the start button.
(3) Adjust the retraction diameter when required.
(4) Press the swaging button until the dies hold the fitting lightly.
(5) Adjust the recommended swaging diameter.
(6) Press the swaging button until the dies stop.
(7) Open the dies and remove the fitting.
(8) Check the swaging diameter.
(9) If necessary, perform fine adjustment with
the swaging diameter dial.
MANUAL MODE
Semi-automatic mode is used when performing small quantities of swages.
(1) Adjust the swaging and retraction diameters.
(2) Select SEMI-AUTOMATIC MODE.
(3) Insert the hose assembly between the dies.
(4) Press the semi-automatic swaging button, and dies perform a swaging-retraction cycle.
The cycle can be interrupted by releasing the button, If need be, dies can be opened by using
the retraction button.
SEMI-AUTOMATIC MODE
CE Instruction Manual
www.samway.com
