WEC8500/8050 Maintenance Manual
Version 5.1
Samsung Electronics America
page 67 of 87
3.3 Problem Creating APs
To create an AP to the APC, the AP is configured using CLI/WEC.
Symptoms
When attempting to create AP executing ‘ap [ap config name]’, the AP is not added.
WEC8500# configure terminal
WEC8500/configure# ap ap_test123
[configApConfig] createApFromCfgName failed. (sApCfgName:ap_test123,
apId:-1, ret:-20)
Possible Causes
The APs has been already configured as many as the number of TotalApNo
TotalApNo is the same as MaxApNo, additional APs cannot be configured.
TotalApNo is the total number of APs that are configured additionally; and MaxApNo is
the maximum number of APs that can be set up additionally.
The procedure to add APs using web UI is described below.
1) On the top menu, click Configuration.
2) On the left menu, click Access Points.
3) Click Add.
4) Click the Security tab.
5) Set AP Profile Name and MAC Address, and click Apply to create an AP.
Solutions
1)
Execute the ‘show apc summary’ command to check TotalApNo, which is set in the
APC.
WEC8500# show apc summary
===== APC Summary =====
ApcName
: APC_007e37001ff0
AP Mgmt interface IP : 100.100.100.1 (vlan1.100)
MaxApNo
: 3000
ActiveApNo
: 22
TotalApNo
: 3000
802.11a/n Radios
: 22/2978
802.11b/g/n Radios : 22/2978
ActiveStationNo
: 0
SecurityAuthType
: X.509
RMacField
: Support
DtlsPolicy
: Both
