OfficeServ 7100
PROGRAMMING
TECHNICAL MANUAL
PART 2 JANUARY 2009
MMC: 724
DIAL NUMBERING PLAN
DESCRIPTION:
[Applies to v.4.22 or Lower]
This MMC allows the technician to change directory numbers for stations, trunks,
station groups, trunk groups and feature access codes. The system can be
preprogrammed with a default three or four digit numbering for station, station
groups and trunk numbers depending on the position of the DIP switches on the
MCP card. Default numbering plan is only assigned once the system is powered up
for the first time OR once the system memory has been manually cleared. There is
an error message provided to prevent the accidental duplication of a directory
number or feature access code.
DIAL OPTION
DESCRIPTION
00
STN NUM PLAN
This is where station directory numbers are changed or
assigned
01
TRK NUM PLAN
This is where trunk directory numbers are changed or
assigned
03
MISC NUM PLAN
This is where directory numbers for relays, MOH ports,
and the Internal Modem are changed or assigned
04
STNG NUMBER
PLAN
This is where station group numbers are changed or
assigned
05
TRKG NUMBER
PLAN
This is where trunk group numbers are changed or
assigned
06
FEAT NUMBER
PLAN
This is where feature access codes are changed or
assigned. Dialing codes are entered via the dial pad key
by pressing the dial pad number, the required steps to
select this feature. For example, for OHVA, the number 6
would be pressed three times. NOTE: Please remember
that this program is system-wide.
07
SO-STN NUM PLAN NOT USED IN USA.
09
NTWK LCR/RS
NUMPLAN
This is where additional LCR access codes are entered in
the case where two or more systems are networked
together. This is to route between 10~1,000 numbers.
Remote Station RS0001~1999 is for individual routing of
station numbers for networking and remote dialing.
10
VIRT EXT
NUMPLAN*
This is where virtual station directory numbers are
changed or assigned.
Home Page
Table of Contents
