iDCS 500 Release 2 / OfficeServ
INSTALLATION
TECHNICAL MANUAL
PART 3 MARCH 2004
3.4
DIP SWITCH USE
on the
iDCS 500 MCP2
ON (left) OFF (right)
4 DIGIT STATION NUMBERS
SW8
3 DIGIT STATION NUMBERS
4 DIGIT STATION GROUPS
SW7
3 DIGIT STATION GROUPS
4 DIGIT TRUNK NUMBERS
SW6
3 DIGIT TRUNK NUMBERS
RESERVED
SW5 RESERVED
COUNTRY SELECT
SW4
COUNTRY SELECT
COUNTRY SELECT
SW3
COUNTRY SELECT
COUNTRY SELECT
SW2
COUNTRY SELECT
COUNTRY SELECT
SW 1
COUNTRY SELECT
z
Switches 1 through 4 select the country the system is installed in.
4 3 2 1
Country
OFF OFF OFF OFF Korea
OFF OFF OFF ON USA
OFF OFF ON OFF UK
OFF OFF ON ON Italy
OFF ON OFF OFF
Australia
OFF ON OFF ON
New
Zealand
OFF ON ON OFF
Holland
OFF ON ON ON
Denmark
z
Switch 5 reserved.
z
These DIP switches will not take effect unless the switches are set in the wanted
position and the system memory is cleared manually by using the Memory Backup
switch.
Install the SmartMedia card. Install daughter board(s). Set the MCP2 DIP switches on the
card to the desired positions. Turn the memory switch on.
Insert MCP2 card in the Cabinet slot labeled MCP/LCP
. Push firmly at
the top and bottom of the card to ensure that it is fully inserted into the back plane
connector. To prevent accidental damage to the MCP2 card, the MCP/LCP connector
on the back plane is positioned to mate only with the MCP2 or LCP2 card. Other
interface cards will not mate with this connector and the MCP2 card will not mate with
any other connector. NOTE:
Do not insert this card with system power ON.
Home Page
Table of Contents