iDCS 500 Release 2 / OfficeServ
INSTALLATION
TECHNICAL MANUAL
PART 2 MARCH 2004
2.1
PART 2. INSTALLING SINGLE CABINET AND
MULTIPLE CABINET CONFIGURATIONS
2.1 UNPACKING AND INSPECTION
The iDCS 500 can be configured as a single cabinet, a dual cabinet system or a three
cabinet system.
A iDCS 500 single cabinet system may be wall, floor, or rack mounted while multiple
cabinets systems may only be floor or rack mounted. Do not attempt to wall mount any
system other than a single cabinet system.
All the iDCS 500 cabinets are identical when shipped from Samsung. After unpacking
the cabinet(s), inspect for signs of physical damage. If any damage is detected, do not
attempt installation. Contact Samsung Telecommunications America’s Technical
Support Department.
Check to see that each iDCS 500 Cabinet carton includes the following items:
z
iDCS 500 Cabinet
z
Top cover
Left and right side covers
•
Front cover
•
Cabinet leg mounting kit
•
AC power and DC power cables
Check to see that all additional 500 hardware and software is available for installation at
this time.
•
Floor mounting equipment (legs or castors), if required.
•
Cards required to make the iDCS 500 system functional. i.e., power supply, central
processor, station and trunk cards
2.2 SINGLE CABINET INSTALLATION – WALL OR
FLOOR MOUNT
A iDCS 500 single cabinet system can be wall-mounted using two screws in the rear
keyholes or floor mounted with the standard legs provided or optional locking castors.
The castor kit must be ordered. Remove side and front covers of the cabinet prior to
installation to avoid damaging the covers and to allow access to the interior.
For a wall mounted system, the cabinet should be securely mounted on a plywood
backboard at least 5/8” thick. Insert into the back board, sixteen inches (16”) apart two
Home Page
Table of Contents
