56
Indoor unit setting
How to connect your extended power cables
1.
Prepare a compressor and the following tools.
Tools
C
rimping pliers
C
onnection sleeve
(mm)
I
nsulation tape
C
ontraction tube (mm)
Spec
M
H
-14
20xØ6.5(
H
xO
D
)
Width 19mm
70xØ8.0(LxO
D
)
Shape
2.
As shown in the figure, peel off the shields from the rubber or wire of the
power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
t
After peeling off the tube wire, you must insert a contraction
tube.
t
For information about the power cable specifications for indoor
and outdoor units, refer to the installation manual.
CAUTION
(Unit: mm)
120
60
20
20
20
180
Power cable
20
Wire tube power cable
3.
Insert both sides of core wire of the power cable into the connection
sleeve.
ۘ
Method 1
Push the core wire into the sleeve from both sides.
C
onnection sleeve
ۘ
Method 2
Twist the wire cores together and push it into the sleeve.
C
onnection sleeve
4.
Using a compressor, compress the two points and flip it over and compress another two points in the same
location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly pressed.
C
ompression
dimension
ۘ
Method 1
C
ompress it 4 times.
5 mm
ۘ
Method 2
C
ompress it 4 times.
5 mm
