Samson TROVIS 5579, Mounting And Operating Instructions

Page: 8 / 182

1.1.2 Rotary switches
Use the three rotary switches to set the required operating mode (icons on the left) and the
relevant parameters (icons on the right) of each control circuit.
The top and middle switches are assigned to the heating circuits (see page 161). The rotary
switch in the middle is not used in systems without a second heating circuit.
The bottom switch is assigned to the DHW circuit (except for systems Anl 5.0, 6.0 and 25.0).
Rotary switch to set the operating modes of the heating circuit
Automatic/time-controlled operation
with switchover between day and night mode
Day mode (rated operation)
Night mode (reduced operation)
Control operation deactivated, frost protection only
Manual operation: correction value adjusted in percent
and activation/deactivation of the pumps
Rotary switch to set the parameters of the heating circuit
Day set point (rated room temperature)
Night set point (reduced room temperature)
Times-of-use for heating
Party mode
Controller time: setting current time, date and year
Rotary switch to set the operating modes of the DHW circuit
Automatic/time-controlled operation
with switchover between times of higher and lower
DHW temperatures
Day mode (DHW temperature set point active)
Night mode (DHW temperature sustained value active)
DHW heating deactivated, frost protection only
Manual operation: correction value adjusted in percent
and activation/deactivation of the pumps
8
EB 5579 EN
Operation