Samson 3731-5, Mounting And Operating Instructions

Page: 97 / 112

EB 8387-5 EN 97
Appendix
Error codes – Recommended
action
Condensed state message active, when prompted, Err appears.
When fault alarms exist, they are displayed here.
67 Test calculation Hardware controller monitored by test calculation.
Status classification Maintenance alarm (cannot be classified)
Recommended action Confirm error. If this is not possible, return positioner to SAMSON for re-
pair.
Data errors
Error codes – Recommended
action
Condensed state message active, when prompted, Err appears.
When fault alarms exist, they are displayed here.
68 Control parameters Error in control parameters.
Status classification [Maintenance required]
Recommended action Confirm error. Perform a reset. Re-initialize the positioner.
69 Potentiometer
parameters
Error in digital potentiometer parameters
Status classification [Maintenance required]
Recommended action Confirm error. Perform a reset. Re-initialize the positioner.
70 Calibration
parameters
Error in data from production calibration. The positioner continues
operation with cold start values.
Status classification [Maintenance required]
Recommended action Return positioner to SAMSON for repair.
71 General parameters Error in parameters not critical to control operation.
Status classification [Maintenance required]
Recommended action Confirm error. Check and, if necessary, change the settings of the
required parameters.
72 Start-up parameters Error in start-up parameters
Status classification [Maintenance required]
Recommended action Confirm error and perform a reset. Re-initialize the positioner.