• (IF PROVIDED) TIGHTEN AND CHECK ALL THE FITTINGS
FOR CONNECTION BETWEEN PUMP, FLEXIBLE HOSE AND
SPRAY GUN BEFORE USING THE EQUIPMENT.
• ALWAYS USE THE FLExIBLE HOSE SUPPLIED WITH STAN-
DARD KIT.
• THE USE OF ANY ACCESSORIES OR TOOLING OTHER THAN
THOSE RECOMMENDED IN THIS MANUAL, MAY CAUSE
DAMAGE OR INJURE THE OPERATOR.
• THE FLUID CONTAINED IN THE FLExIBLE HOSE CAN BE VERY
DANGEROUS. HANDLE THE FLEXIBLE HOSE CAREFULLY. DO
NOT PULL THE FLEXIBLE HOSE TO MOVE THE EQUIPMENT.
NEVER USE A DAMAGED OR A REPAIRED FLEXIBLE HOSE.
The high speed of travel of the product in the hose
can create static electricity through discharges
and sparks. It is suggested to earth the equipment.
The pump is earthed through the earth cable of
the supply.
The gun is earthed through the high pressure
flexible hose.
All the conductors near the work area must be
earthed.
Avoid approaching too much to the pump piston
rod when the pump is working or under pressure.
A sudden movement of the piston rod can cause
wounds or finger squashing.
Never spray over flammable products or solvents
in closed places.
Never use the tooling in presence of potentially
explosive gas.
Always check that the product is compatible with
the materials composing the equipment (
pump,
spray gun, flexible hose and accessories
) with
which it can come into contact. Never use paints
or solvents containing Halogen Hydrocarbons
(
as the Methylene Chloride
). If these products
come into contact with aluminium parts can
provoke dangerous chemical reactions with risk
of corrosion and explosion.
If the product to be used is toxic, avoid inhalation
and contact by using protection gloves, goggles
and proper face shields.
Take proper safety measures for the protection
of hearing in case of work near the plant.
• KEEP YOUR WORK AREA CLEAN AND IN ORDER
• KEEP THOSE WHO ARE NOT ACCOUNTABLE OUTSIDE THE
WORKSPACE.
• BEFORE USING THE EQUIPMENT, THE OPERATOR MUST BE
TRAINED AND INFORMED ABOUT THE LOCATION OF ALL
CONTROLS ON YOUR EQUIPMENT.
• DO NOT EXCEED THE INDICATED MAXIMUM PRESSURE.
• RELEASE THE PRESSURE IN THE CIRCUIT BEFORE
CARRYING OUT ANY TYPE OF CONTROL OR PRODUCT
REPLACEMENT POLICY.
• DO NOT MODIFY THE SUPPLIED PARTS, ALWAYS A LOOK
REGULARLY TO YOUR SYSTEM'S COMPONENTS. REPLACE
ANY DAMAGED OR WORN PARTS.
• TIGHTEN AND CHECK ALL THE RACCONDI OF CONNECTION
BETWEEN PUMP, HOSE AND GUN BEFORE OPERATING
EQUIPMENT.
• DO NOT GET TOO CLOSE TO THE HOIST DURING HIS
MOVEMENTS.
While the drive is operating do not touch the
moving parts, in order to avoid possible injury to
your hands and fingers.
Do not dispense flammable products or solvents
indoors never use the equipment in the presence
of explosive gases, always check if the product is
compatible with the materials that compose the
equipment (
pump, gun, hose and accessories
)
may come into contact with them.
If the product to be used is toxic, avoid inhalation
and contact by using protective gloves, goggles
and masks.
THESE INSTRUCTIONS REFER TO THE CORRECT USE OF THE PNEUMATIC HOIST.
IN ADDITION, READ CAREFULLY THE INSTRUCTIONS CONTAINED IN THE RELATED MANUALS THE DIFFERENT
COMPONENTS (
PNEUMATIC PUMP, DELIVERY GUN, ETC.
) WHICH CAN BE USED WITH THE PNEUMATIC HOIST.
www.larius.com
4
ED. 10 - 07/2020 - Cod. 150133
Pneumatic hoist twin mast for 200 litres
