Fig. 13M
Fig. 12M
• The hoist is now ready for operation. It may be necessary to
act on the hoist thrust air regulator to increase the pressure
of the hoist.
Fig. 14M
• Lower the pressing plate (
M7
) by turning the control lever
(
M2
) downwards until the plate enters the drum and positions
itself on the product.
• Close the vent valve (
M9
) when the product starts to come
out in the absence of air bubbles.
NOTE
If the pressing plate inclines when inserting the drum,
rotate the control lever up. Rise the pump and then
repeat the operation.
Never under any circumstances plate hands
between the plate and the edge of the drum.
The pressing plate may suddenly come out when
removing it from the drum: BE CAREFUL OF
HANDS AND KEEP HEAD AWAY FROM MOVING
MACHINE PARTS.
KEEP IN MIND THAT THE EXTRUSION RAM IS
ALWAYS HAND PUSH. ONCE THE GASKET HAS
ENTERED INTO THE DRUM, THE PRESSING
PLATE-PUMP LOCK MAY MOVE SUDDENLY TO
REACH THE SURFACE OF THE PRODUCT. BE
CAREFUL OF HANDS AND KEEP HEAD AWAY
FROM MOVING MACHINE PARTS.
www.larius.com
16
ED. 10 - 07/2020 - Cod. 150133
Pneumatic hoist twin mast for 200 litres
M7
M2
M9
