41
9.1
Possible symptoms of faults - Causes of faults - Remedies to apply
Defaults
Root causes
Remedies
•
Paint no longer comes out of
the gun
•
Nozzle partially or completely
clogged
•
Disassemble and clean the
nozzle with solvent and a
smooth brush
•
Check the condition of the
seal.
•
The spray narrows at pump
reversals.
•
Viscosity too high.
•
Dilute the paint.
•
The head frequently gets dirty
•
Too much air.
•
Reduce air pressure.
•
The paint comes out through
the air holes in the head.
•
Defective nozzle seal.
•
Replace it.
•
Insufficiently tight nozzle
•
Tighten it.
•
Product leakage at the trim
level
•
Worn seal.
•
Tighten the liner press
without blocking the
needle.
•
If the leak is still present,
replace the seal and
needle.
•
Product leakage at the front of
the gun, trigger released
•
Impurities in the product
•
Worn out needle or/and worn
out nozzle
•
Pull the trigger 3 or 4
times and let it go back on
its own.
•
Replace the needle and/or
nozzle.
•
Air leakage at the valve
•
Worn valve
•
Changing the valve
•
Permanent air leakage at the
gun head when trigger is
released
•
Rubbing on the needle
•
Worn valve
•
Remove the trigger and
check that the needle
slides freely.
•
Replace the valve.
Summary of Contents for FPro G
