EN
39
INSTALLING THE APPLIANCE
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
1. Remove the pan supports, the burner lid
and flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
2. Take care that the Ignition devices and
flame supervision devices are not damaged
in this operation.
3. Apply the sponge provided around the edge
of the appliance.
4. Do not leave a gap in the sealing agent or
overlap the thickness.
5. The thickness of the sponge is 3 mm. The
width of the sponge is 10 mm.
Do not use a silicon sealant to seal
the appliance against the aperture.
This will make it difficult to remove
the appliance from the aperture in
future, particularly if it needs to be serviced.
1. Place the bracket(B) over the holes that
match the size of the screws. There are
one set of screw holes in each corner of
the hob(H). Slightly tighten a screw(C)
through the bracket(B) so that the bracket
is attached to the hob, but so that you can
still adjust the position .
2. Carefully turn the hob back over and then
gently lower it into the aperture hole that
you have cut out.
3. On the underneath of the hob, adjust the
brackets into a position that is suitable
for your worktop. Then fully tighten the
screws(C) to secure the hob into position.
Summary of Contents for Masterchef Line Executive PSC-VH-1060
Page 42: ...N O T E S 44 ...
