EN
34
TO IGNITE A BURNER:
Press in the control knob of the burner that
you wish to light and turn it anti-clockwise to
the maximum position.
If you keep the control knob depressed, the
automatic ignition for the burner will operate.
You should hold down the control knob for 15
seconds after the flame on the burner has lit. If
after 15s the burner has not lit, stop operating
the device and open the compartment door
and/or wait at least 1 min before attempting
a further ignition of the burner.
After this 15-second interval, to regulate the
flame you should continue turning the control
knob anti-clockwise until the flame is at a
suitable level. The operating position MUST
be at a position between the maximum and
minimum position.
To switch the burner off, turn the control knob
fully clockwise to the gas off position.
In case of power failure, the burners can be
lit by carefully using a match.
SAFETY AND ENERGY SAVING ADVICE
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
The diameter of the bottom of the pan should
correspond to that of the burner.
Do not use cookware that overlaps
the edge of the burner!
BURNERS
PANS (mm)
Triple-Crown
200-240
Semi-Rapid
160-180
Auxiliary
120-160
NO
YES
Do not use small diameter cookware on large
burners.
The flame should never come up the sides of the
cookware.
Always use cookware that is suitable for each burner,
to avoid wasting gas and discolouring the cookware.
Avoid cooking without a lid or with the lid half off - as
this wastes energy
Place a lid on the cookware.
Summary of Contents for Masterchef Line Executive PSC-VH-1060
Page 42: ...N O T E S 44 ...
