![background image](http://html1.mh-extra.com/html/salvis/vitality-pro-sds-1-1-13/vitality-pro-sds-1-1-13_installation-and-operating-instruction_3686685061.webp)
en
61
Filling the water softener
.
Unscrew the water softener cap.
.
Confirm removal of the cap
−
press
key.
D
The display next to the clock
flashes
D
Wait about a minute until you hear the buz-
zer and
appears in the dis-
play.
.
Add approximately 0.5 kg regeneration salt.
D
The regeneration salt must be specially suited for water softening units and be quick dissol-
ving.
.
Replace the cap on the water softener.
.
Confirm closing of the softener
−
press
key.
D
The buzzer falls silent.
D
The display next to the clock flashes
D
The control system measures the conductivity of the water (takes approximately 40 se-
conds):
−
If insufficient salt has been added, or if the salt has not dissolved sufficiently, a buzzer
sounds and the display shows
again
−
in this case, wait a while until the
salt has dissolved and repeat filling the water softener.
−
If the correct quantity has been added and the salt has dissolved, the display shows
and the regeneration process runs.
D
The remaining regeneration time is displayed.
D
Once the regeneration process is completed, the appliance switches itself off.
Repeating the regeneration process if ”Er 78” appears in the display
D
If the conductivity of the water is too high after regeneration, the display shows
There is still some salt in the softener.
.
Repeat the regeneration process (programme 99) without adding salt so that the salt re-
maining can be flushed out.
Cap
Filling hole