30
9.
Preheat – Cool Down Active Temp
The combi steamer should always be preheated, respectively cooled down.
When selecting the function “Active temp“ the temperature in the oven cavity is brought to a
pre-set nominal temperature. Consequently this function offers two procedures.
In case the cooking chamber temperature is below this nominal value, the cavity is heated up.
In case it is too high for the following cooking program, the cavity is cooled down.
To make understanding following easier, we explain the function “preheating“,
cool down works exactly the same way, only the other way round.
For both there are two possibilities:
1. Step Preheat
When selecting this function, it is defined as first step of a cooking program = here
preheating
.
•
Having
entered
all cooking steps
, proceed to “Additional functions”, mark “Active temp”.
•
Activate
1st Step = Preheat
with
OK
and start the program by pressing
.
•
Any opening of the door during preheating, interrupts the
preheating
process.
Close the door and preheating is continued until the pre-set nominal temperature is reached.
Once it is reached, there is a sound signal and the info line indicates
Preheat - Cool End
.
The sound signal is repeated over and again until the door is opened.
•
The nominal temperature is maintained for 1 hour max.
•
Charge the oven and shut the door. The program starts automatically with the before entered
cooking steps.
•
Once the preheating process is stopped by the operator by touching the sensor key
Preheat OFF,
it is possible to start directly with the first cooking program step after having
charged the oven.
•
Such a program, including preheating, can also be stored. The symbol
is then marked in the
program list.
2. Manual Preheat
Manual preheating is possible. The nominal temperature is then 10% higher than the temperature
of the cooking program.
•
Select this function via sensor key Preheat.
•
Proceed as described under preheating 1st Step= Preheat. The preheating function is added to
the cooking program.
•
The function manual preheating cannot be stored as part of a cooking program.
•
It is possible to deactivate the Cool Down function via sensor key Service in the list of Unit
parameters.
•
It is possible to add the 1st Step= Preheat or manual preheating also to the special functions
such as Banquet, LT-Cooking, Cook&Hold and
∆
T-Cooking.
•
Further functions are selected via Additional functions as usual.
