SainSmart Genmitsu PROVerXL 4030, User Manual

Page: 12 / 39

11
Step 1:
Inspect your Base Assembly after removing it from the
packaging. Before starting assembly, verify the base is square
by using a 90-degree straight edge, as shipping may have
caused things to shift.
Step 2:
Install the flexible coupler onto each Y-Axis leadscrew.
Loosen the small set screw to ensure the Lead Screw will
completely seat inside.
Step 3:
Tighten (2) M6 x 16mm screws to secure the lead
screw mount.
Step 4:
Next comes the Motor Mounts & Stepper Motor.
Lay the Stepper Mount on your flat surface, positioning it
so the open side will not face down when installed. Place
the NEMA-23 Motor onto the mount aligning the screw holes.
Insert the M5 x 50mm screws.
Step 5:
Holding the Mount & Motor together with the screws,
install the assembly to base as shown in the diagram.
35 7
6
31
2