2
3
Safety instructions - Please Read Before Installation
WARNING: INSTALLATION TO BE PERFORMED BY
PROFESSIONAL INSTALLERS ONLY
Note:
These instructions for the installation of the MorphoAccess
assume the installer is properly qualified as a professional,
familiar with applicable industry standards, local building/zoning
codes, and proper installation practices. Installation should not
be attempted by non-professionals.
You are required to use a National Electric Code Class 2 power
supply at 12 V DC ± 5% and 2.5A minimum. This product is
intended to be installed in accordance with the NEC Class 2 r
equirements.
Europe:
SAGEM SA hereby declares that the SAGEM SA
MorphoAccess™ has been tested and found compliant with
the below listed standards as required by the EMC Directive
89/336/EEC: EN55022 (1994) / EN55024 (1998) and by the low
voltage Directive 73/23/EEC amended by 93/68/EEC: EN60950
(2000).
USA:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
If this equipment interferes with radio or television reception
(which can be determined by disconnecting and re-connecting
the unit), the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer for help.
Safety instructions