8
9
For other types of surfaces you should select an appropriate
anchor that is rated to support a minimum of 5 lb (2.25 kg).
See Appendix 2, p. 26 for generic bolt specifications.
Note:
A variety of fasteners can be used to mount the
MorphoAccess to different types of material. The mounting
holes must be prepared according to the type of fastener
being used for an installation and the type of material
the MorphoAccess is being mounted against. Use "best
practices" installation procedures for the type of fastener
being used.
8. Once the fastener locations are properly prepared for accepting
the fasteners, temporarily mount the MorphoAccess to the
mounting surface to check for proper alignment of the
fasteners and placement.
9. To temporarily mount the MorphoAccess, lift the device into
position near the junction box and place the wire stubs inside
the junction box in order to position it against the mounting
surface.
10. Fasten the device to the mounting surface with the four
fasteners.
11. If you are satisfied with the mounting, remove the device
from the wall and place it in a safe location, away from your
work area. If you need to make an adjustment, remove the
MorphoAccess from the wall and make the adjustment
accordingly.
You are now ready for the final installation procedure.
Positioning and preparing the MorphoAccess
