Safex FlowMarker II, Instruction Manual

Page: 18 / 36

17
/
34 • GAFM-II-10.12
Do not blow fog on hot surfaces, into open flames or into glowing heating ele-
ments etc.!
The normally non-flammable and non-toxic fog can decompose on hot, red glowing sur-
faces (> 380°C) or in open flames.
Heat sources like lamps, central heating or other closed heating systems or electric ma-
chines without red-glowing parts or small flames like candles, laboratory burner etc.
bear
no hazard and need not to be given attention.
Use the FlowMarker
®
only in dry condition; do not pour water over the device or immerse
it in water. Any dirtying with aggressive media, dust, solvent, etc. may cause serious
damage.
The FlowMarker is not suitable for use in explosive environment. It has no EX
protection. Never use it in close proximity to open containers with inflammable
liquids or in saturated areas with fumes of inflammable liquids or gases.
Due to physical processes, longer or improper use will inevitably result in some fog fluid
condensing inside the application tube.
The condensed fluid can easily be wiped off with a paper towel or washed off with water.
Remove fluid drops or spilled fluid on the ground, as viscous fluids create a risk of skid-
ding.
Fluid absorbent rings are available as accessory. They are inserted on both ends of the
application tube.
The larger ring KR2 has to be inserted from the „threaded“ side of the application
tube until it fits behind the air inlet holes at the recess . It must not cover the air holes!
The smaller ring KR3 has to be inserted from the muzzle side of the black tube until it
has completely slipped in.
The rings will absorb possible fluid condensation. They have to be replaced periodically
dependent on how intensive the device is used.
The SAFEX
®
FOG FLUID AEROSOL CAN is under pressure. The propellant N
2
is non-
inflammable, non-toxic and environmentally safe.
The pressurized fog fluid can, like any aerosol can, must never be heated above
50°C, opened by force, or burned.
When entirely empty, dispose of it with domestic refuse.
The battery of the FlowMarker
®
is a sealed lead-acid-gel-battery. If it is no longer usable,
dispose of it according to local regulations!

By no means open or burn the battery, or short-circuit the battery poles.

Should, in case of damage, any acid gel escape from the battery, immediate-
ly rinse the affected parts of the body with ample water. If eyes are affected,
rinse first, then immediately consult a physician.
Before use, check the battery safety screw to prevent the battery from falling out (See
chapter B „Inserting Battery).
For unattended transport, take the battery out of the device. Prevent the battery
contacts from being short-circuited by conductive materials. Serious fire hazard! During
transport cover battery contacts with non-conductive material (e. g. insulating tape)
SLIP HAZARD
FLUID CAN
BATTERY