SAFETRACK ECONECT PinBrazing, User Manual

Page: 13 / 24

7
GENERAL MAINTENANCE
13
EQUIPMENT
- Always make sure the batteries are fully charged.
- Check the cables from time to time for damage.
- Check the contact surface on the ground magnet to ensure a good connection.
- Make sure that the brazing pin with the ferrule passes easily in the gun, centered.
BRAZING PINS AND FERRULES
- Keep them dry.
RAILBONDS AND CABLE LUGS
- Keep them free from oxidation.
- Keep them free from contamination like: Grease, oil.
- Make sure that they are not damaged.
SETTING RIGHT LIFT HEIGHT
The S15 brazing gun self adjust to the same lift height every time.
See separate instructions (page 16-17) if adjustment for the gun is necessary.
PIN HOLDERS
Squeeze the fingers on the pin holder together each time you feel that the brazing pin goes in
too easy when mounting them into the pin holder. This is important since all the current goes
thru the pin holder to the brazing pin. If the fingers are too loose the pin holder will be damaged
and must be replaced.
REPLACE THE FUSES:
Push and unscrew anti-clockwise to remove fuse holder.
Replace fuse and mount fuse holder.
NOTE!
Control: 5A fuse
Grinder: 15A fuse
•
Check that the pin holder is not burnt and holds the pin tightly. If not, remove the ring holder,
clean all the parts and squeeze the fingers of the pin holder together.
•
Check the cables on the gun from time to time for damage. Replace as required.
•
Check that the lift level is correct with lift the level tool.
•
Always store the tool in a clean dry space, safe from damage or pilferage.
•
Always keep critical equipment markings, such as warning stickers and tags legible.
•
Equipment repair should be performed by experienced personnel only.
•
Do not use the equipment for applications for which it was not intended.
In addition to the Safetrack Precautions in this manual,
observe the following for equipment protection and care.
NOTICE