2.
Upload configuration file
- allows uploading system configuration file to CFIP Lumina
flash memory. In order to load configuration file from system memory,
cfg restore
should be used (refer to number 9);
3.
Saved configuration file - shows contents of system configuration file saved in
EEPROM memory. Commands contained in this configuration file are executed at
every system start-up;
4.
Running configuration file - shows currently running system configuration file
(command line –
cfg show
). In order to save current configuration use command
cfg
write
;
5.
Delete entry number from running configuration file –
allows deleting a specific line
from currently running system configuration (refer to number 4); (command line –
cfg delete
<line>
);
6.
Save edited configuration file –
allows save running system configuration
permanently in EEPROM memory (changes applied since the last start of the
system) (command line –
cfg write
);
7.
Execute current configuration
– executes commands present in currently running
system configuration file (command line –
cfg run
);
8.
Input file name to backup cfg in system memory
– allows choosing file name under
which currently running system configuration file will be saved in the CFIP flash
memory (command line –
cfg backup
<file>
);
9.
Input file name to restore cfg from system memory –
allows loading system
configuration file from backup file located in flash memory (command line –
cfg
restore
<file>
). To view the contents of flash memory refer to number 18;
10.
Enter string, which you want to save in cfg
– allows you to enter desirable
command, which will be added to running system configuration file as the last line
(command line –
cfg add
<cmdline>
);
11.
Load factory configuration file
– Resets system configuration by loading in EEPROM
the script with default settings. This command performs the following actions (in
the following order):
1. clears the currently saved system configuration file from EEPROM,
2. creates and stores new system script in EEPROM the with the
following settings:
- net ip addr 192.168.205.10 or 192.168.205.11 (as marked on
the label)
- net ip remaddr 192.168.205.11 or 192.168.205.10
- net ip mask 255.255.255.0
- net ip gw – 255.255.255.255 (default gateway - none)
- SNMP trap 255.255.255.255 (none)
3. restarts the management controller.
(command line –
cfg factory
);
12.
Backup Ethernet configuration file
– allows choosing file name under which
currently running Ethernet configuration file will be saved in the CFIP flash memory
(command line –
ethernet config
<file>
);
13.
Download current Ethernet configuration to PC
– allows downloading Ethernet
configuration file and saving it on your hard drive.
14.
Upload Ethernet configuration file
– allows uploading Ethernet configuration file to
CFIP Lumina flash memory. In order to load Ethernet configuration file from system
memory, appropriate dialog should be used - refer to number 15;
15.
Run/restore Ethernet configuration from file
– allows loading Ethernet configuration
file from backup file located in flash memory. To view the contents of flash memory
refer to number 18;
The CFIP Lumina Series Full Outdoor Unit Technical Description and Configuration Guide • Rev. 1.10 •
© SAF Tehnika JSC 2013
