4.3
IP Configuration Window
The IP configuration window provides configuration of the Ethernet management port
addressing, IP services and routes. Settings listed here are essential for building a network or other
specific traffic purposes.
Explanation of customization fields:
4.3.1
Ethernet management port IP configuration
1.
IP Address
– allows specifying IP address of CFIP Lumina you are currently logged in.
Default IP address is 192.168.205.10 or 192.168.205.11 – depending on which side
the specific CFIP Lumina is – low side has 192.168.205.10 IP address and high side –
192.168.205.11 (command line –
net ip addr
<addr>
);
2.
IP Mask –
allows specifying IP mask of CFIP Lumina you are currently logged in.
Default IP mask is 255.255.255.0, and it should not be changed unless you are
owning network with huge amount of hops (command line –
net ip mask
<mask>
);
3.
IP Default gateway –
allows specifying gateway of CFIP Lumina you are currently
logged in. Default gateway is 255.255.255.255 which means that there is no
gateway specified (command line –
net ip gw
<gw>
);
4.
Ethernet MAC address –
shows the MAC address of CFIP Lumina you are currently
connected to (command line –
net mac
);
5.
Remote IP Address –
shows IP address of remote (far-end) CFIP Lumina to ensure
communication between link sides (command line –
net ip remaddr
<remaddr>
);
6.
Pressing
„Execute configuration”
applies changes made to the corresponding
section only for the local side CFIP Lumina. If
„Rollback on”
is selected, configuration
will be reverted in case of erroneous configuration changes applied.
4.3.2
IP Services
1.
FTP service –
starts FTP service for file access and software update of your CFIP
Lumina. By default FTP service is not running (command line –
net start ftp
);
2.
TFTP service –
starts TFTP service for file transfer between both CFIP Lumina link
sides. By default TFTP service is not running (command line –
net start tftp
).
cold
– Restarts modem as well.
System contact
<contact>
Allows to specify contact person for this managed node.
Ver
Displays hardware and software version of FODU, as well as built date.
(!)
Note that CFIP Lumina IP addresses need to be in the same subnet.
The CFIP Lumina Series Full Outdoor Unit Technical Description and Configuration Guide • Rev. 1.10 •
© SAF Tehnika JSC 2013
