SAESHIN TRAUS SSG10, User Manual

Page: 31 / 48

28
■ SAW mode
1. Press the motor button ( / ) to select the motor to use.
2. Set the SAW mode by using the mode button ( ).
3. Press the irrigation button ( ) on the control box or irrigation button ( ) on the foot controller to select the irrigation volume.
Irrigation volume per each stage refers to the below.
4. Press the speed button ( ) to set the speed. ▶ button for increasing speed, ◀ button for decreasing speed.
Keep pressing speed button to change rapidly. It can set from 5,000 to 12,500 cycle/min.
5. Use it by pressing the speed control pedal on the foot controller.
35 ml/min ± 25% Irrigation stop 50 ml/min ± 25% 65 ml/min ± 20% 80 ml/min ± 20% 90 ml/min ± 20%
- Before operating product, please check the connection of irrigation tube on SAW angle. If irrigation tube isn’t connected and delivered
to blade, there is risk of tissue necrosis or bone damage. Because of the frictional heat between blade and operation site.
(Installation method of Irrigation tube: Refer to the connection of each part.)
- If you use the SAW angle, make sure that the mode set as SAW before use it. If you do not set the SAW mode, there is a risk
of an accident.
- Gear ratio and torque are fixed for SAW mode.
- Gear ratio: 3:1
- Torque: 10 N·cm