SAESHIN TRAUS SSG10, User Manual

Page: 29 / 48

26
OPERATION PROCESS
■ DRILL mode
1. Press the motor button ( / ) to select the motor to use.
2. Set the DRILL mode by using the mode button ( ).
3. Press the gear ratio button ( ) to select the gear ratio to use.
4. Press the operation direction button ( ) on the control box or operation direction button ( ) on the foot controller
to select the operation direction. Operation direction is forward and reverse in DRILL mode. During the reverse operation, it beeps
continuously. (Sounds let the user know the operation direction.)
5. Press the irrigation button ( ) on the control box or irrigation button ( ) on the foot controller to select the irrigation
volume. Irrigation volume per each stage refers to the below.
6. Press the speed button ( ) to set the speed. ▶ button for increasing speed, ◀ button for decreasing speed.
Keep pressing speed button to change rapidly. The setting range of speed is different from gear ratio, refer to the below.
35 ml/min ± 25% Irrigation stop 50 ml/min ± 25% 65 ml/min ± 20% 80 ml/min ± 20% 90 ml/min ± 20%
1:1
300~40,000 rpm
1:3
900~120,000 rpm
1:5
1,500~200,000 rp m
10:1
30~40,000 rpm
20:1
15~2,000 rpm
32:1
10~1,250 rpm
7. Press the torque button ( ) to set the torque. ▲ button for increasing torque, ▼ button for decreasing torque.
The setting range of torque is different from gear ratio, refer to the below.
9. Use it by pressing the speed control pedal on the foot controller.
- Optic function is applied to ‘M2 DRILL mode’ only.
8. Press the optic button ( ) to use optic function.
Gear ratio
Torque
1:1
1 ~6 N· cm
1:3
1~2 N · cm
1:5
1 N · c m
10:1
5~30 N·cm
20:1
5~80 N·cm
32:1
5~80 N·cm
- Before operating product, please check the connection of irrigation tube on DRILL angle. If irrigation tube isn’t connected and delivered
to blade, there is risk of tissue necrosis or bone damage. Because of the frictional heat between blade and operation site.
(Installation method of Irrigation tube: Refer to the connection of each part.)
- If you use the DRILL angle, make sure that the mode set as DRILL before use it. If you do not set the DRILL mode,
there is a risk of an accident.
Gear ratio
RPM