SAESHIN TRAUS SSG10, User Manual

Page: 39 / 48

36
Lubrication Product List
· Angle handpiece
Lubrication method
· Insert the nozzle to motor assembly part(the end part of angle) and spray lubricant 2~3 seconds.
DRILL Angle
<TRAUS TST10XX> <TRAUS CST10XX, TRAUS CRT14XX>
- Do not insert the oil into the motor. It damages the bearing or causes fever.
- If the continuous operation, please put the oil every an hour.
- When lubrication, please hold the angle handpiece firmly because the angle handpiece can go out by the spray pressure.
3. Lubrication
●
SAW Angle
<TRAUS TRT12NRC, TRAUS TRT12NOS,
TRAUS TRT12NSG>
●
SHAVER Angle
<TRAUS TRT12NSH>
●
Sterilization Product List
·
Angle handpiece
·
Motor (Assembling with motor cap)
Sterilization Method
① Dry the applicable products completely.
② Put the applicable products in a sterile bag and seal tightly.
※ Make sure to assemble the motor cap for autoclave on the motor.
※ Do not disassemble the motor and motor cord when sterilizing.
③ Put the sterile bag in the sterilizer and sterilization for 4 minutes with 132℃, and let it dry for 30 minutes.
- This product is designed to withstand 250 times of re-sterilization process.
- Moist steam sterilization only. Otherwise the products might be damaged.
- Make sure to use the sterilization bag and seal tightly.
- Make sure to dry the applicable products before sterilization.
- Motor could be damaged in sterilization because of the moisture inflow or else, so should be careful to handle it.
- Sterilizing the angle handpiece with blood or other remains may cause the breakage of the angle handpiece.
Therefore, it is necessary to clean the angle handpiece before sterilization.
- Sterilize the DRILL bur, SAW blade, SHAVER blade according to each manufacturer’s manual.
- Irrigation tube is disposable. Do not use it again.
- Keep dry a connector and socket of the control box.
- Before using, dry the product completely.
2. Sterilization
Sterilization
Moist heat sterilization 132℃
Temperature
4 minutes
Time
30 minutes
Dry Time
132