SAESHIN TRAUS SSG10, User Manual

Page: 17 / 48

BUTTONS ON OPERATION PANEL
Mode button
: This is used for selecting the mode (DRILL, SAW, SHAVER).
Program button
: This is used for selecting the memorized program number.
By pressing the button, the program changes by 1 stage.
The program returns to number 1 (P1) after number 9 (P9).
Gear ratio button (DRILL mode)
: This is used for selecting the gear ratio of the handpiece used during the procedure.
Operation direction button (DRILL, SHAVER mode)
: This is used for selecting the direction of rotation (Forward, Reverse, F/R repetition motion).
During reverse operation, it beeps continuously.
Optic button (DRILL mode – Motor 2)
When press the speed control pedal on the foot controller after operating the optic function,
LED is turned on at the angle head part. Release the speed control pedal, turn off the LED after 3
seconds. Turn off the optic function, LED is not operated regardless pressing the speed control pedal.
Optic function is only operated by Optic angle and Optic motor.
Stage
Irrigation button
: This is used for selecting the irrigation volume.
It can control stage 0 to 5 (Max. 90 mℓ/min ± 20%).
Motor1 button
: This is used for selecting the motor 1.
0
1
2
3
4
5
Stage 0: STOP
Stage 1: 35 ml/min ± 25%
Stage 2: 50 ml/min ± 25%
Stage 3: 65 ml/min ± 20%
Stage 4: 80 ml/min ± 20%
Stage 5: 90 ml/min ± 20%
> 1:1 -> 1:3 -> 1:5 -> 10:1 -> 20:1 -> 32:1
Motor2 button
: This is used for selecting the motor 2.
Speed button / Setup - Item shifting button
- Speed setting:
This is used for setting the speed.
▶ button for increasing speed, ◀ button for decreasing speed
Keep pressing speed button to change rapidly.
※ The setting range of speed is different from mode and gear ratio.
- Setup mode - Item shifting: This is used for selecting the setup item.
Torque button / Setup - Setting button
- Torque setting:
This is used for setting the torque of DRILL handpiece.
* DRILL mode: ▲button for increasing torque, ▼ button for decreasing torque
※ The setting range of torque is different from gear ratio.
- Setup mode - setting: This is used for setting the sound level, time and reset.
Memory button / Setup button
- Program memory: Keep pressing this button for 3 seconds after completed setting program,
program is memorized with beep sound.
- Setup mode: Volume control, Time set, Program reset, Auto Calibration is available.
- Setup complete: Press this button in order to memorize the program in SETUP mod e.
Volume
14
- Optic function is applied to ‘M2 DRILL mode’ only.