Sachs Bikes madass, Repair Instructions

Page: 215 / 218

212

TROUBLESHOOTING
Electric
Complaint Symptom and possible causes Remedy
Some electric components are
without function, for instance
indicator lamps, horn, starter Faulty connection at the round plugs Secure a correct contact by straighten
the plugs
Cold soldered points at the handlebar switch Exchange the handlebar switches or
solder the contacts again
Faulty plugs at the ignition switch Secure a correct contact
Rear indicator wire blown. Might
concern the fi rst series
production Pole at the indicator wire mix up Exchange indicator lamps and
connect correctly
Fuse blown Short- circuit at the cable Search for short- circuit and repair
Failure of the complete electric
system Battery to frame body without ground contact Repair ground contact to the frame
body
Fuse blown or without contact Change fuse and fi nd out the reason
Indicator and rear light indicate
with interplay Battery is not charged, voltage below 10 V Charge battery
Indicator wire with low ground Secure the isolation
Light gets darker if the turn light
is active A certain voltage is normal and can not be
repaired
Battery voltage below 12 V Recharge battery. Check if the battery
will be charged by running engine
Head light bulbs blown all the
time. Only for vehicles without
clutch switch! Diode defect or without contact Remove the diode and connect the
contacts so that the regulator can
adjust the voltage
Light gets darker during high
rpm’s and shines brighter by
using the turn lights. Only for
vehicles without clutch switch! Faulty interaction between diode and regulator. together for adjusting the regulator
voltage.
Disconnect the yellow/ white wire
at the head light area. Connect the
yellow/ white wire form the right
handlebar together with the black
wire (+ cable neutral light). This is
necessary for the power supply over
the ignition lock to the light.
Please use in this case the adapter
wire cord!
Order no. P9864905001000
Light power too low After all remedies the standard bulb is still too
weak Install a high beam bulb
Order no. P4064905001001405
Caution!
Not licensed for use on normal
traffi c conditions
Starter motor without function Starter relay defect Change starter relay
Speedometer without function Batteries run down Change batteries
Order no. 2 pieces
P4064905001003310
Batteries run down (about two weeks) Change speedometer
Moisture gets in the speedometer Change speedometer
Rear light without function Several LED with poor soldered points Change complete LED rear light