Ryobi SDS65, Operator'S Manual

Page: 6 / 32

6 — English
FEATURES
PRODUCT SPECIFICATIONS
Chuck Capacity .......................................................... SDS+
Drilling Capacity:
Concrete ....................................................................1 in.
Metal ...................................................................... 1/2 in. Switch .............................. Variable Speed Reversible (VSR)
Blows Per Minute ..........................................0-4,200 BPM
No Load Speed .................................. 0-1,000 r/min. (RPM)
Input ...............................120 V, AC only, 60 Hz, 6.5 Amps
ASSEMBLY
UNPACKING
This product requires assembly.

Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this
Assembly
section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.

Inspect the product carefully to make sure no breakage
or damage occurred during shipping.

Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.

If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
AUXILIARY HANDLE ASSEMBLY
See Figure 1, page 11.
The drill is equipped with an auxiliary handle assembly. For
ease of operation, use the handle with either the left or right
hand. The handle can be rotated 360°.

Loosen the handle assembly by turning the handle coun-
terclockwise.

Slide the auxiliary handle assembly onto the hammer drill
in the desired operating position.
NOTE: Make sure the notches on the inside of the auxiliary
handle engage the tabs on the drill housing.

Securely tighten by turning the auxiliary handle clockwise.
NOTE: Be sure the auxiliary handle is securely tightened
against the depth stop rod clamp. This secures the depth
stop rod at the desired depth of cut. It also secures the
auxiliary handle.