Ryobi RPD500, Original Instructions Manual

Page: 4 / 116

English
2
Ŷ
After each period of operation, exercise to increase
blood circulation.
Ŷ
Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
,QMXULHVPD\EHFDXVHGRUDJJUDYDWHGE\SURORQJHGXVH
of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 81.
1. Keyless chuck
2. Drill/impact shift knob
3. Forward/ reverse button
4. Lock-on button
5. Trigger
6. Auxiliary handle
7. Handle, insulated gripping surface
MAINTENANCE
WARNING
The product should never be connected to a power supply
ZKHQ \RX DUH DVVHPEOLQJ SDUWV PDNLQJ DGMXVWPHQWV
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
DFFLGHQWDOVWDUWLQJWKDWFRXOGFDXVHVHULRXVLQMXU\
WARNING
When servicing, use original manufacturer’s replacement
parts. Use of any other parts may create a hazard or
cause product damage.
Ŷ
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
'RQRWDWDQ\WLPHOHWEUDNHÀXLGVJDVROLQHSHWUROHXP
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
Ŷ
Electrical tools used on fiberglass material, wallboard,
VSDFNOLQJ FRPSRXQGV RU SODVWHU DUH VXEMHFW WR
accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc. We
do not recommend using the product for extended work
on these types of materials.
WARNING
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
Ŷ
If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
Ŷ
For greater safety and reliability, all repairs should be
performed by an Authorised RYOBI Service Centre.
LUBRICATION
All of the bearings in the product are lubricated with a
VXI¿FLHQWDPRXQWRIKLJKJUDGHOXEULFDQWIRUWKHOLIHVSDQRI
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
V Volts
Hz Hertz
Alternating current
W Watts
n
o
No-load speed
PLQʚï
Revolutions or reciprocations per minute
Class II tool, double insulation
Wood
Metal
Masonry
Impact drill mode
Chuck capacity
CE conformity