Ryf Ryeco RMM2010-CNC, Operating Instructions Manual

Page: 3 / 24

Operating Instructions Ryeco RMM2010 - CNC
1.4 Warranty, product liability
The measurement device left our factory in a perfect condition. At the time it showed no signs of
defects in accordance with the Civil Code and no faults in accordance with the Product Liability
Act.
All of the technical information, specifications and notes relating to the operation of the
measurement device, provided in these operating instructions, have been compiled and reviewed
carefully. They meet the latest technical standards for the measurement device at the time of
printing and are based on our experiences and technical expertise gained to date.
In the event of any defects or faults arising on the delivered measurement device or the supplied
documentation and in the event of any culpable mistakes on our part, the content of the warranty
and liability framework shall be exclusively governed by the regulations set out in the main contract
relating to the acquisition. In this context, we also refer you to our general terms and conditions of
business, which form an integral part of all of our business agreements. With the exception of
liability according to statutory law as per the Swiss Product Liability Law, any further claims,
especially claims for compensation, are excluded.
Any warranty claims must be submitted to Ryf Ltd. within the warranty period immediately after the
defect or fault has been detected. The warranty period is specified in our final order confirmation.
The warranty shall not cover normal wear, especially function-related wear of all wear parts
installed in the measurement device.
2 Intended uses
2.1 General information about the intended use
Workshop microscopes from the RMM2010 series are optical or optical coordinate measurement
devices and may be used for the following purposes (= intended use):
• All models: Optical coordinate measurement of two-dimensional geometries (e.g.
points, lines, distances, circles, radii, angles) using the integrated transmitted and/or incident light
illumination.
• Details on the measurement range and maximum workpiece weight is provided in the
measurement range is dependent on the model. The maximum work piece size that can be
measured is determined from the measurement range of the measurement device. The following
must also be observed:
• The workpiece must be designed in such a way that it can be positioned securely or
fixed on the measurement table, ensuring that it cannot fall down and that the workpiece
and measurement device (sensor or housing) do not collide when the measurement
table is moved.
• Specifications regarding the measurement range apply to the primary sensor (camera).
If other sensors are used, the effective measurement range is reduced because of the following
conditions:
Offset between camera center point and probe tip center point.
Characteristics and offsets of other sensors.
It must be ensured that the measurement table is loaded evenly as this could otherwise
influence the measurement result.
The measurement device is designed for stationary applications
Any use of a RMM2010 that is not in accordance with the specified provisions and/or parameters is
deemed to be contrary to the intended use for which Ryf Ltd. shall not assume any liability for
damage or malfunctions.