Installation
Vistage™ Series Flat-Panel Display Installation/Operation Manual
17
PRE
L
IMINAR
Y
3.4
Connections to the
V-50HD/V-63HD and
DHD Controller
Proceed as follows to connect the DHD Controller to the V-50HD/V-63HD, your video
sources, external controller(s) – if present – and AC power.
To access the rear-panel connectors, use a Phillips screwdriver to loosen the screws
securing the protective cover plates (see Figure 2-3) to the panel, then remove the plates.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don’t use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connecting the DHD
Controller to the
V-50HD/V-63HD
Connect the
HDMI Out To Di
s
play
connector on the DHD Controller to the
PRIMARY
INPUT
connector on the V-50HD/V-63HD. See Figure 3-2. Then, re-attach the input
cover plate, routing the cable through the nearest slot on the plate.
Figure 3-2. Connecting the V-50HD/V-63HD to the DHD Controller
Use an HDMI cable for this connection.
A DVI cable with
DVI-to-HDMI adapters will not work.
Caution
SECONDARY
INPUT
SERVICE
PORT
PRIMARY
INPUT
Video 1
Y
Video 2
Video 3
Pr
Pb
RS-232
HDMI 2
HDMI 4
Ethernet
HDMI Out
To Display
HDMI Out
Audio Only
Pr
R
Pb
B
Y
G
HD1
HD2
H
V
RS-232
deo 1
Y
V
Video 1
ideo 2
Video 3
Pr
Pb
HDMI 2
HDMI 4
Ethernet
HDMI Out
Audio Only
Pr
R
Pb
B
Y
G
HD1
HD2
H
V
HDMI Out
To Display
PRIMARY
INPUT
