59
Resetting the Access Point to Factory Default Settings
Configuring the 5GHz Antenna Gain
10
Resetting the Access Point to Factory
Default Settings
You can reset the Access Point to its factory default settings by shorting pins 3 and 4 on
the DC connector. Use the electrical shunt that is provided with the Access Point package
to perform this procedure.
NOTE:
The Access Point can only be reset to factory default if it is using PoE.
1.
Verify that the Access Point is using PoE as its power source.
2.
Take out the electrical shunt that is supplied with the Access Point.
3.
If the DC connector on the Access Point is protected by its cap, remove the cap. Take
note of the location of pins 3 and 4 (see
Figure 44
).
Figure 44.
Note the location of pins 3 and 4
Pin 4
Pin 3
