48
Attaching the Mounting Brackets
Step 1: Attach the Static Bracket to the Mounting Surface
Figure 37.
Insert a wall anchor into each hole that you drilled, align the holes on the
bracket with the wall anchors, and the secure the bracket with the flat
washers and the hex nuts
9.
Using a 10mm open-end wrench, tighten the nuts to secure the bracket to the
mounting surface. Screw torque value must be 0.4-0.5 Newton meter (Nm). As you
tighten the nuts, the metal cones that are built into the wall anchors will expand and
lock the wall anchors into place.
10.
Continue to
“Step 2: Attach the Dynamic Bracket to the Access Point”
.
Attaching the Bracket to a Pole
The Access Point can be mounted vertically or horizontally on a 30mm to 60mm (1.18 in.
to 2.36 in.) pole.
1.
Insert the open end of one steel clamp into the upper two tabs on the bracket.
2.
Take the other steel clamp and insert it into the lower two tabs on the bracket.
Wall anchor
Metal cone
Flat washer
Hex nut
