5.2)
General Options
5.2.1)
Buzzer
5.2.2)
Backlight
Enable or disable the internal buzzer. Select either ‘On’ or ‘Off’
Controls the LCD Display Backlight. Select either ‘On’, ‘Off’ or ‘Auto’. The auto function
will turn the display on whenever a key is pressed. If after 20 Seconds no key has been
pressed the display backlight will turn off.
5.2.3)
Sidelight Cut-out
When enabled, the Sidelight Cutout will disable Channels
5
and
9
whenever the
illumination
signal
is active. Select either ‘On’ or ‘Off’.
5.2.4)
CAN Bus
5.2.5)
Handheld
5.2.6)
HRT Single Tap
This selects the CAN Bus interface mode.
Currently only Ford Focus is supported
with this function. Select ‘0’ to de-activate, or select ‘1’ to enable the Ford Focus option.
The CVS012 currently supports the MHE RS485 Handheld, the Generic Handheld S-Link
series of handheld controllers, or manual only control.
See 1.6) RS485 Serial Interface
This enables the HRT Single Tap Function. Select either ‘On’ or ‘Off’.
See 1.1) Siren
System HRT
5.2.7)
Runlock Timeout
This setting defines the number of minutes the Runlock Function will remain enabled before
automatically cutting out. Select ‘0’ to disable this function, or set the number of minutes
required.
See 1.2) Runlock System
5.2.8)
Splitter Charger Off
This setting defines the ‘Turn Off’ voltage levels for the Splitter Charger system.
See 1.3
Splitter Charger System
5.2.9)
Splitter Charger On
This setting defines the ‘Turn On’ voltage levels for the Splitter Charger system.
See 1.3
Splitter Charger System
5.2.10)
Siren Tones
Standard Yelp
Standard Wail
UK Two Tone
UK Yelp
UK Wail
Pulsar
Standard Two Tone
5.2.11)
Manual Inputs as Handheld
When set to ‘Off’ the manual inputs (
See 3.4 Manual Inputs Connector
) 1 to G control
outputs 1 to G respectively. Voltage dropouts and current monitoring is employed to
protect the channel, as per the channel settings, but no output mode is applied. The channel
will remain active as long as the input is high, and the voltage and current conditions are
suitable.
When set to ‘On’ the manual inputs act the same as a handheld input.
5.2.12)
Siren Auto Scroll
If enabled, the siren tones will automatically scroll through the tone list every 5 seconds
5.2.13)
Siren Auto Airhorn
If enabled, the Airhorn will briefly sound between Siren Auto Scroll (see above) tone
changes.
5.2.14)
Siren Enable Start
If enabled, the siren tones will begin scrolling whenever the Siren System is enabled. The
tones can be controlled by normal HRT thereafter.
