RS SAILING RS Quest, Rigging Manual

Page: 25 / 86

23
Make sure the port side is fully inserted into
the track and then insert the starboard side
into the track opening. This can be a little
tricky as you will need to bend it back on
itself to get to the opening, but as long as the
starboard side is fully inserted first it shouldn’t
be too hard.
In the spinnaker pack there should be some elastic
for the rear of the spinnaker chute.
Use this elastic to tie the aft end of the spinnaker
chute to the eyelet (with the 30mm block on it) on
the port side of the cockpit.
If you have the foredeck option, you should fit it at this point
(See section 5). If not then move on to section 6.
d)
e)
4.5 - Adding the Spinnaker Sock