Roxell Minimax Line, Use And Assembly Manual

Page: 75 / 94

ROXELL - 001 - 3503 MINIMAX LINE -- INSTALLAITON INSTRUCTIONS
III--23
Fix the auger to the drive shaft of the gearhead with
the drive block.
FIGURE 63. FIGURE 64.
Clamp the auger under the drive block.
Put the thin edge
towards the gearbox.
Pull the auger until it stretches, then let it relax. Mark the
auger at the edge of the feed intake boot.
FIGURE 65. FIGURE 66.
Tighten the bolt with a
spanner, so that it cannot be
twisted off by hand !
Feed intake boot.
M
ALWAYS SEE THAT THE AUGERCANNOT SPRING BACK(BY USING CLAMPS) WHENYOU
PUT IT UNDER TENSION.
Stretch the auger 1,7cm per 3m tube. Measure the
required stretch from Mark M to the feed intake boot.
Here you put a new mark NM Slide the anchor into the auger until the auger touchesthe
anchor end.
FIGURE 67. FIGURE 68.
Now put a pliers past this mark NM Let the auger slide
back into the tube until the pliers rest against the feed
intake boot.
Firmly tighten the set screw in the middle of the anchor, so
it will expand and clamp the auger.
Cut the auger with a hacksaw or
grinding machine.
NM
M