Roxell Minimax Line, Use And Assembly Manual

Page: 70 / 94

MINIMAX LINE -- INSTALLATION INSTRUCTIONS ROXELL - 001 - 2112
III--18
LINE SUSPENSION
MAKE SURE THAT THE MAIN CABLE 5mm DOES NOT HANG IN, BUT BESIDE THE SCREW
HOOKS AND PULLEYS !
Hang a SMALL PULLEY on each SCREW HOOK.
Slide a piece of suspension cord through each pulley (towards the central winch)
Fix this cord at 15cm from the pulley to the main cable 5mm with a cable clamp.
CABLE CLAMP
MAIN CABLE
CENTRAL
WINCH
FIGURE 44.
Make a loop around the tube.
Push the end of the cord in the needle opening.
Pull the needle through the cord.
Respect these measurements !
Remove the needle.
MAIN CABLE
BESIDE SCREW
HOOKS AND
PULLEYS !
FIGURE 45.
Start suspending from the central winch. Proceed to both ends until the whole feeder line is suspended.
Determine the length of cord to be cut as follows :
-- pull the cable downward under slight tension until it touches the tube.
-- add 55cm.
CUT BY MEANS OF A SOLDERING IRON OR AN ELECTRICALLY HEATED KNIFE.
REMARK : AFTER INSTALLATION OF THE PANS, WHEN THE LINE HANGS LEVEL, YOU CAN INSERT
THE CORD END BACK INTO THE CORD. THIS ADDS TO THE HEIGHT THE LINE CAN BE RAISED AND
ALLOWS A NEATER FINISH.